The
main work of reinforcing mesh (or also known as REO mesh) is used to improve
the tensile strength of concrete. This prevents cracks to the structural
elements. As such, the mesh is manufactured from welded wire or prefabricated Brisbane steel reinforcing mesh.
These
come in a variety of sizes. Mostly, they come in square grids or rectangular
patterns.
Uses
This
square mesh is a general purpose concrete reinforcing mesh used for flat
concrete areas like floors or walls. These D500L grand ribbed wires are welded
together during manufacture in order to make those square apertures.
Rectangular mesh / Ute mesh
The
rectangular mesh is used for walls and concrete floor slabs. It is a
reinforcement product which is fabricated from D500L grade ribbed wires. The
design is ideal when additional strength is required for a chosen direction.
The Ute
mesh is a specifically designed and manufactured to fit safely (and legally)
onto the back of Utes and trucks without any dangerous overhangs. This allows
the sheets to be transported safely. Given their size, ute mesh sheets are able
to be handled by one person.
Trench mesh
The
trench mesh is used primarily for residential footing trenches and concrete
beams. It is manufactured from D500L ribbed wire using a range of longitudinal
wires which can be up to 12v millimeter in diameter.
Trench
Mesh is used primarily for residential footing trenches and concrete beams.
Reozone manufacture it from D500L ribbed wire using a range of longitudinal
wires which can be up to 12mm in diameter.
Welded mesh fabric
The
welded mesh fabric is generally used in surface beds (concrete floor slabs on
fill) and road pavements. The mesh is
also used in suspended floor slabs, concrete retaining walls, box culverts, and drains, precast
stadium seating, tilt-up wall panels among others.
With
the use of welded mesh, the construction process speeds up. This is now
available in wide range of wire diameters with each one suited for a particular
reinforcing design application.
Depending
on the job requirements, welded mesh can be designed either in flat sheets,
rolls or bent to suit the need of the present project. The deformed wire used in the production of welded
mesh improves concrete adhesion.
Welded
mesh can be used at higher stresses than that of high tensile rebar. This
yields 8% overall material savings. Due to its rigid nature, concrete cover can
be controlled more accurately on site.
Manufacturing standard
Welded
mesh is manufacture in strict compliance to SANS1024 Standard Specifications as
well as to international specifications on request. Where there is a
significant amount of repetition, conventional bar reinforcement can be
substituted with pre-manufactured designed mesh resulting in easier controls,
speed of installation, reduction of cuts and wastage.
The
welded mesh fabric reinforcement is manufactured using cold-rolled deformed were,
electrically resistance welded at the intersections of the longitude and
transverse wires at the required mesh spacing with minimal loss of strength and
cross-sectional area.
For the
best Brisbane steel reinforcing mesh, the latest state-of-the-art equipment was used to
produce the best steel mesh to suit its specific needs.
Comments
Post a Comment